Well, Yea Forums?

This.

5 isn't blocked. There is holes in the block.

2 Fills up first, every other route is blocked.

6 IS THE ONLY ONE NOT BLOCKED OFF

2

Attached: z.jpg (860x960, 79K)

Spill jokes.

Attached: germ.jpg (300x168, 4K)

4 and 5 pipes seem "closed" to me. The next one that would come and stays open is the one to 6

2 and then 7

Retards

Not video games.

They're all blocked off

Attached: 1552201111763.png (2400x2510, 1.57M)

Attached: 2.jpg (860x960, 82K)

Then you explain it.

It could easily trickle into 3, if it's slow enough, but I still day 2.

nvm, it's closed right at the end, disregard this post. don't bully me pls

2 because it will drip in off the side

Attached: number 5.png (800x602, 59K)

Attached: 7D1B3E6C5B2E4FFB89882944344CC335.jpg (380x380, 23K)

Attached: XxmMjXGfGOsmaEK-800x450-noPad.jpg (410x230, 14K)

1 and 2 the rest are cut off.

Attached: fucking retard.jpg (860x960, 85K)

Did somebody say "BULLY"?

Attached: 1548301337442.gif (461x346, 149K)

Depending on flow rate, it will either achieve laminar flow off over the edge into cup 2, or, due to fluid tension/water tension, kinda drip between2 and 3 messily

200 IQ here, proper order:
video games
videao gaemes
vidya gams
gameo vids
veni vidya vici

>

it's 6 you tards, the water has to hit the bottom first and fill up, the cup that will receive water earliest will be 6

Depends on the speed of the pouring.

7-3 and 1 is blocked off. So the liquid would fill up the tubes leading to 6-3 and then start spilling out into the gap between the tube s that lead to 3 and 1. From there, it depends on how the liquid moves. If it's spraying out fast, it'll hit the outside of 1's tube and fall down into 1's cup. If it's spraying out slower, it might just fall into 2's cup. If it's going real slow, it might just follow along the edge of 3's tube and wind up into 3.

Guys come on, i just thought this is like the view of the pipe. I just compared it too late with the others

Attached: 1387101186158.png (577x558, 325K)

One and six are unblocked. It honesty depends on how the water is being poured in. Since the teapot is aimed at the left I would say 6. Also it has the angle to pour fast enough but not all will go into 6 some will stay in the pipes.

It's 2 kid. Look closer.

actually

Attached: 1552221154736s.jpg (223x250, 13K)

The surface tension and flow rate of the liquid would likely cause it to run down the side of the tube into 3

2

Attached: sketch-1552221714801.png (1080x1206, 306K)

Six is blocked

Good argument

What? Only 6 will get orange juice. Teh others are blocked.

Attached: 1552149333823.png (441x524, 193K)

FUCK SIX IS BLOCKED IT WOULD BE 2 THEN DUE TO THE HOLE FUCK.

The physics are near right, but the conclusion is wrong. The liquid would actually adhere down the tube side of the tube and drain into 3 first. Nice try.

the flow is so slow 2 will fill up faster.

6 is blocked at the end, retard

If the pour is slow, then 5 could fill up first

edge is too sharp, if it was smooth and the tube is quite large

if its three dimensional 4 would fill up.

I go one step further and say it depends on the material of the pipes, faggot.

SMELLS LIKE LAYTON IN HERE

5 and 2

they're all blocked except a hole which might leak into cup 2, cup 1, or neither, depending on the pressure.

That edge ain't too sharp, 4 as a solution also works.
and the temperature.

Git good, could be cups 2-4 based on the conditions

Now hold on just a second. It's impossible to know that for sure. We know nothing about the actual liquid, the type of material the pipe is made out of, or the speed of the pour. I say the intelligent move is to take the average possibility or to not respond to bait threads.

1

Attached: 1552221154736.jpg (860x960, 103K)

Almost!
The answer to the question, "which is full first", is of course
The teapot

FUCK YOU LAYTON

There wont be much pressure, its only being poured in after all.
If the material of the pipes lets it, the water may stick to it and pour into 3, otherwise it'll be 2

>hey look how hard i can pour

The picture shows that some liquid is already dripping out of the teapot, so it's not full anymore.

My first question would be why the tea glasses are numbered from right to left and not left to right like normal human beings would do.

Depending on much water is in the pot and how quick it's poured.

Attached: Untitled.jpg (860x960, 96K)

based

>how quick it's poured
Is there even a way to pour "quicker"?
Its just gravity. You cant will it to pour faster

>only one not blocked it 6
What did faggot OP mean with this?

It might slide down from the kinked pipe down to 3 instead of going to 2, same for 1

2

This

Guess again nerd.
And then guess another time.

Imagine being THIS retarded

2
Everything else is blocked off under the hole

The angle can make more or less liquid come out of the spout during the pour. Also pouring continuously or periodically makes the difference between filling up all the way to let cup 7 get some, or it all going into 2

Brainlet

Attached: 1552221154736s.jpg (223x250, 15K)

Gee it sure is video games in here.

6 is blocked retard
All of them are blocked

mah boi, this offtopic is what all true shitposters strive for

Shut up nerd

Solved it for you, OP.

Attached: op.jpg (761x588, 63K)

Post the fucking Layton puzzles already you niggers

No video game talk allowed on Yea Forums

Fucking mods, this was about video game physics

>projecting this hard

Fucking mods. I had (you)s dammit!

/Thread/

It's actually the only one that has a shot...
If that gap counts as an opening.

Attached: Screenshot_20190310-140842_Chan Burauza.jpg (1440x1442, 242K)

Attached: 1550808974392.jpg (421x834, 94K)

Trick question. The pipes are very thin, so the water will be attracted to the walls. It will end up moving down down the top pipe junction and fill up cup 1 because of capillary action.

5 will get filled and the rest of the water will overflow that cup.

This
5 and 4 are blocked off so 6 will get filled and overflow till there's no more black water.

5 is blocked off.

This
All the rest are blocked off.

Depends how sharp the edge is on 7. If its curved, then the water or mecury will follow but, if its sharp, then it'll just shoot off.

7 6 5 4 3 1 are blocked

2 gets filled then 7 both by overflow of main pipe

3. The water wouldn't go into cup 2, but instead stick to cup 3's pipe. Of course this all depends on the water flow speed.

Attached: aaaaaaaaaaaaaaaaaaaaaaaaaaaaaa.png (1341x1567, 669K)

this thread is making me angry

[spoiler]op is a faggot[/spoiler]

This user is thinking.

This

Soo...nice one Elon.

Attached: gy1suoyzady0lhd2j228941177600.jpg (1650x1136, 130K)

>finally getting it to sound like english

Attached: 1551326090629.jpg (1150x720, 150K)

you are my an hero

If the flow adheres to the outside of the tubes, 2, 3, 6 & 7 are the ones most likely to get fluid in them, allowing for some straight dripping off the one tube.

Attached: maxresdefault.jpg (1280x720, 42K)

2, then 7, then 1

oops, should add 3 would fill up before 1

Attached: derp.jpg (860x960, 96K)

isnt this jewish Christmas?

I'm still waiting for my tea you fuckwits. Get a move on.

This is correct. Since the liquid is not pouring at full speed, but rather simply overflowing from another source, it won't be travelling fast enough to leap from the edge. It would mostly adhere and fill #3 first.